Can the welding process of the adhesive strip of the rear partition board of the car coat and cap stand be welded by ultrasonic equipment?

Can ultrasonic equipment be used to weld the adhesive tape binding welding process of the rear partition of the automobile coat rack?

Ultrasonic welding technology of adhesive tape binding for rear partition of automobile coat rack

There are many processes for automotive plastic interior parts, and the processes required for different products are also different. Here, I'd like to introduce to you the binding process of the coat rack, also known as the back clapboard.

The adhesive tape is wrapped around the outer edge of the coat rack partition, and then the two are combined by a fixed form. A long time ago, the process used to use glue, but with the improvement of the welding process of the car interior, this method is gradually replaced, because its environmental protection and firmness need to be strengthened, and the production rhythm and cost are relatively expensive, So now the general auto parts manufacturers use ultrasonic welding technology to solve this product's edge wrapping process. According to the production capacity requirements and cost considerations, Suzhou youwo ultrasonic also provides customers with different ultrasonic welding equipment, including portable and overall non-standard ones, with their own advantages and different choices. The principle is through the high-frequency ultrasonic vibration, under pressure to make the adhesive strip and diaphragm body molecular fusion, so as to bond together. Portable equipment can solve the equipment investment of small enterprises when the production rhythm is not fast and the production cost is low; Non standard equipment, can quickly improve production efficiency, but also for different products for rapid die welding processing, can solve the production needs of mature customers.